|
STORAGE |
|
|
All rolls of Lead should be stored in a clean dry
area and ideally off the floor on a wooden pallet.
|
|
|
|
|
Unsealed concrete or rough floors will leach
moisture and alkalis into the Lead rolls causing
staining. |
|
|
|
|
Any contact with moisture will ingress into the
layers of a Lead roll by capillary action and create
red oxide staining (similar to rust) in a matter of
hours. (This can sometimes be removed by using a
nylon scourer and ordinary vinegar). |
|
|
|
|
Where possible, Flashing rolls of 450mm width or
less should be stood on end to minimize the risk of
damage. Wider rolls should be laid on pallets. |
|
|
|
|
Always remember that the surface of Lead can be
scored or damaged if it comes into contact with
rough surfaces. |
|
|
|
HEALTH AND SAFETY |
|
Lead in its metallic state does not present a health
risk provided that a few simple precautions are
followed: |
|
|
|
|
Always wear work-gloves when handling Lead. |
|
|
|
|
Always wash your hands and forearms as soon as you
finish and before you do anything else. |
|
|
|
|
Do not eat, drink or smoke after handling Lead,
prior to washing your hands. This applies even if
gloves have been worn. |
|
|
|
|
When sweeping a Lead storage area, damp down any
dust and wear a protective mask. |
|
|
|
|
When welding Lead follow guidelines and wear eye
protection. |
|
|
|
For a comprehensive Health & Safety Data
Sheet click on the MSDS Bar at Top of Page |
|
|
|
HANDLING |
|
However obvious it may sound, people forget that a
piece of Lead is always heavier than it looks. |
|
|
|
|
Always follow the correct lifting guidelines. |
|
|
|
|
Never attempt to lift a roll of Lead on your own
unless you are confident of your ability to handle
it without undue effort. |
|
|
|
|
If in doubt, either insert a strong steel bar
through the roll and lift with the help of another
person or employ approved mechanical handling
equipment. |
|
|
|
|
Always wear a pair of gloves to protect from both
Lead dust (see Health & Safety notes) and sharp
edges. |
|
